Tag Archives | esxi

How To: Disable warnings when SSH enabled vSphere ESXi 5.0

By admin on February 8, 2012 in General

I previously wrote an article about how to enable SSH in vSphere 5.0. A few people have asked how to disable the warnings that then appear on the hosts when you have this feature enabled. The VMware KB article Cluster warning for ESXi Shell and SSH appear on an ESXi 5 host explains how to disable this warning. The following steps explain how to disable this warning: Select the ESXi host from the Inventory. Select Advanced Settings from the Software menu. Navigate to UserVars > UserVars.SuppressShellWarning. Set the value from 0 to 1. Click OK.

Continue Reading 3

HowTo: Enable SSH on vSphere ESXi 5.0

By admin on February 8, 2012 in General

Back in 2010 and I wrote a quick article on How To: Enable Remote Tech Support mode and SSH on ESXi 4.1. A few people have posted comments asking if I could do the same now that vSphere/ESXi 5.0 has been released. The actual steps haven’t really changed, however Remote Tech Support mode is now just simply called SSH. The steps listed below explain how to enable SSH on an ESXi 5.0 host. Login to vCenter Select your host Click the configuration tab Select Security Profile under Software Click Properties for Services Select SSH and click options Choose the startup policy that you require Click Start Click OK and OK SSH to your host Once enabled you will notice that the host within vCenter has a warning being shown. When selecting that host, and looking under the summary, vCenter alerts you to the fact that SSH is enabled.

Continue Reading 4

Enable ESXi Shell vSphere 5.0

By admin on February 7, 2012 in General

Today I was playing around with building some virtual ESXi hosts and could not get one of them onto the network. I tried everything I could through the console UI, but knew I had to enable the ESXi shell command line to do some further digging. These are the steps that I carried out to do this: Connect to the ESXi host console Hit F2 Enter the username and password Select Troubleshooting Options Select Enable ESXi Shell and hit return Press Escape to exit Hold Alt and press F1 Login to the ESXi shell Once logged in you will see the command line If you are unsure of the commands to use the document Command-Line Management in vSphere 5.0 for Service Console Users is a really good starting point.

Continue Reading 2

Older posts Newer posts

Navigation

Tag Archives | esxi