Tag Archives | 4.0

Modifying VMware View 5.0 HTTPS port

Yesterday I installed VMware View into my home lab and configured everything successfully. What I discovered was that my router could not do was any Network Address Port Translation (NAPT) so I could not redirect the external IP port 444 to the internal server IP port of 443. I run a web server on port 443 so could not use this external port for View Connection Server. So how do I change the IP Port on the View Connection Server itself? After googling some scenarios I found a link to this page on myvirtualcloud.net. This is an excellent article, however it only covers View 4.0.x. In View 5.0 there is no locked.properties file in View 5.0, only config.properties and settings.properties. The article above recommends changing the entry “serverPort=xx” in locked.properties however there is no entry for this in either of these files. Hmmmm what to do… In the example below […]

Continue Reading 3
vCloud Ecosystem components explained

vCloud Ecosystem components explained

During VMworld Chris Colotti and I presented quite a few group discussions on VMware vCloud.  During these discussions some people were amazed to find out how many components/products are involved in making up the vCloud environment.  When planning on building a VMware vCloud, you are not just installing vCloud Director and pointing it to vSphere, you are designing/building a whole Ecosystem. The list below shows which components are used in building a full vCloud environment.  They are listed in order of priority. vSphere ESXi vCenter vCloud Director vShield Manager vCenter Chargeback Vcenter Update Manager vCenter Orchestrator vCloud Service Manager vCloud Connector So why are these components important?  When designing a vCloud environment, you need to take into consideration the availability of certain components, like vCenter for example.  This is no longer a management tool that is used to manage your virtual infrastructure.  This is a critical component of your vCloud […]

Continue Reading 4
Cannot add groups to vCD after configuring LDAP

Cannot add groups to vCD after configuring LDAP

I discovered today building a new vCD 1.5 home lab, that once you configure the System LDAP, you dont have the option to add any LDAP groups. This confused me, it was possible to do this in 1.0.x. Why isn’t it available in 1.5? What I discovered is that the GUI is still configured for non LDAP authentication. Once you have configured LDAP and started the synchronization log out of the vCloud Director GUI and back in. You will then see that groups is listed under the administration tab. The GUI needs to update its configuration options. Simple solution, but still confusing until you realise.

Continue Reading 1
Copyright David Hill Group Limited

Powered by WordPress. Designed by Woo Themes